Cisco Cisco Videoscape Voyager Vantage 3.2 用户指南
46
Manufacturer Diagnostics
Introduction
Confirm the network parameters for the RF network.
DOCSIS Status
Verify the status of the DOCSIS network operations on your system.
Determine if the DHCT is running in DSG mode.
Verify the DNCS MAC and IP addresses.
DOCSIS Events
Determine the level of the events listed.
Determine the most recent occurrence of DOCSIS events.
Determine how often the events occur.
DSG Filters
Determine the destination MAC and IP addresses for a DSG tunnel.
Determine the number of packets that have been filtered through a tunnel.
SEB Status
Determine whether the SEB feature is enabled on the eCM.
Determine the current role and figure of merit of the eCM.
Note:
This feature is no longer supported. This screen will be removed in a future release.
SEB Connected Devices
Determine the MAC address and device type of the SEB Client.
Determine the client-side TCP port number and IP address of the SEB tunnel.
Determine the server-side TCP port number and IP address of the SEB tunnel.
Note:
This feature is no longer supported. This screen will be removed in a future release.
DOCSIS DSID Forwarding
Determine the Downstream Service Identifier (DSID) and its types.
Determine the channel number and number of packets forwarded in a particular DSID.
Determine the Cable Modem Interface Mask (CMIM) of the DSID.
Note:
This screen applies only for G8 and G10 set-tops.
DOCSIS Downstream
Verify the downstream interface index (ifIndex), channel ID, and status.
Determine the downstream frequency, modulation, and interleaving interval.
Determine downstream forward error correction (FEC) code information.
Note:
This screen applies only for G8 and G10 set-tops.