Cisco Cisco Tunnel Terminating Gateway (TTG)
Global Configuration Mode Commands (T-threshold phspc)
▀ threshold nat-pkt-drop
▄ Command Line Interface Reference, StarOS Release 18
5710
threshold nat-pkt-drop
Configures alarm or alert thresholds for the percentage of Network Address Translation (NAT) packet drops.
Product
NAT
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold nat-pkt-drop high_thresh [ clear low_thresh ]
default threshold nat-pkt-drop
default
Configures this command with the default threshold settings.
Default: 0—disabled
Default: 0—disabled
high_thresh
Specifies the high NAT packet drop percentage threshold that must be met or exceeded within the polling
interval to generate an alert or alarm.
interval to generate an alert or alarm.
high_thresh
must be an integer from 0 through 100. A value of 0 disables the threshold.
Default: 0
clear low_thresh
Specifies the low NAT packet drop percentage threshold that must be met within the polling interval for a
clear alarm to be generated.
clear alarm to be generated.
low_thresh
must be an integer from 0 through 100. A value of 0 disables the threshold. If not set, the
high_thresh
will be the high and low threshold setting.
Default: 0
Usage
Use this command to configure the NAT packet drop threshold settings.
Example
The following command sets the NAT packet drop threshold settings to a high of
55
% and a low of
15
%:
threshold nat-pkt-drop 55 clear 15