Cisco Cisco IP Phone 8841 设计指南
Cisco Wireless IP Phone 8821 and 8821-EX Wireless LAN Deployment Guide
77
On the Wireless > Configure > Access control page, recommend to enable Bridge mode, where the Cisco Wireless IP Phone
8821 and 8821-EX will obtain DHCP from the local LAN instead of the Cisco Meraki network; unless call control, other
endpoints, etc. are cloud-based.
Once Bridge mode is enabled, the VLAN tagging option will be available.
8821 and 8821-EX will obtain DHCP from the local LAN instead of the Cisco Meraki network; unless call control, other
endpoints, etc. are cloud-based.
Once Bridge mode is enabled, the VLAN tagging option will be available.
It is recommended to enable VLAN tagging for the SSID.
If VLAN tagging is utilized, ensure that the Cisco Meraki access point is connected to a switch port configured for trunk mode
allowing that VLAN.
If utilizing Cisco Meraki MS Switches, reference the Cisco Meraki MS Switch VoIP Deployment Guide.
If VLAN tagging is utilized, ensure that the Cisco Meraki access point is connected to a switch port configured for trunk mode
allowing that VLAN.
If utilizing Cisco Meraki MS Switches, reference the Cisco Meraki MS Switch VoIP Deployment Guide.
https://meraki.cisco.com/lib/pdf/meraki_whitepaper_msvoip.pdf
If utilizing Cisco IOS Switches, use the following switch port configuration for ports that have Cisco Meraki access points
connected to enable 802.1q trunking.
connected to enable 802.1q trunking.
Interface GigabitEthernet X
switchport trunk encapsulation dot1q
switchport mode trunk
mls qos trust dscp
switchport trunk encapsulation dot1q
switchport mode trunk
mls qos trust dscp