Cisco Cisco ACE Application Control Engine Module 技术手册
Configure ACE in Routed Mode with L7 Policies
Document ID: 107400
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Configure
Network Diagram
Configurations
Verify
Troubleshoot
Related Information
Prerequisites
Requirements
Components Used
Conventions
Configure
Network Diagram
Configurations
Verify
Troubleshoot
Related Information
Introduction
This document provides a sample configuration for the Application Control Module (ACE) configured in
routed mode with Layer 7 (L7) policies. The ACE makes a load balancing decision based on specific content
in the URL.
routed mode with Layer 7 (L7) policies. The ACE makes a load balancing decision based on specific content
in the URL.
This sample uses two contexts:
The Admin context is used for remote management and Fault Tolerant (FT) configuration.
•
The C1 context is used for load balancing.
•
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
This document is not restricted to specific software and hardware versions.
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Conventions
Refer to the Cisco Technical Tips Conventions for more information on document conventions.
Configure
In this section, you are presented with the information to configure the features described in this document.