Cisco Cisco 10 Gigabit Modules 安装指南

You will need these tools to install the 10-Gigabit XFP transceiver modules:

Wrist strap or other personal grounding device to prevent ESD occurrences.

Antistatic mat or antistatic foam to set the transceiver on.

Fiber-optic end-face cleaning tools and inspection equipment. For complete information on 
inspecting and cleaning fiber-optic connections, see the white-paper document at this URL: 

The XFP transceiver module is a static-sensitive device. Always use an ESD wrist strap or similar 
individual grounding device when handling XFP transceiver modules or coming into contact with system 
modules.

To install an XFP transceiver module, follow these steps:

Remove the XFP transceiver module from its protective packaging.

Do not remove the optical bore dust plugs until directed to do so later in the procedure.

Check the label on the XFP transceiver module body to verify that you have the correct model for your 
network.

Position the XFP transceiver module in front of the XFP socket opening on the line card. Slide the XFP 
transceiver module part of the way into the transceiver socket on the line card front panel. 

Remove the optical bore dust plug from the XFP transceiver module.

Pivot the bail clasp up so that it is parallel with the transceiver module body. (See 

, top view.)

Continue sliding the XFP transceiver module into the socket until the XFP transceiver module is mated 
with the socket connector. 

Latch the XFP transceiver module in the transceiver socket by pivoting the bail clasp down so that the 
bail clasp is perpendicular to the transceiver body. (See 

, bottom view.)

If the latch is not fully engaged, you may accidently disconnect the XFP transceiver module.

Immediately reinstall the dust plug in the XFP transceiver module optical bores. Do not remove the dust 
plug until you are ready to attach the network interface cable.