Cisco Cisco 2600 3600 Series 8-Port Analog Modem Network Module 技术手册
Wireless Point−to−Point Sample Configuration and
Command Reference
Command Reference
Document ID: 9216
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Configure
Network Diagram
Configurations
Verify
Troubleshoot
Command Reference
Startup Commands
Installation and Configuration Commands
Operation Commands
Monitoring Commands
Troubleshooting Commands
Related Information
Prerequisites
Requirements
Components Used
Conventions
Configure
Network Diagram
Configurations
Verify
Troubleshoot
Command Reference
Startup Commands
Installation and Configuration Commands
Operation Commands
Monitoring Commands
Troubleshooting Commands
Related Information
Introduction
This document outlines how you acquire an operational point−to−point wireless link. This document contains
the necessary components and commands to establish a link, and explains the commands and their use. For
further information, refer to the Cisco Broadband Fixed Wireless Site Planning Guide.
the necessary components and commands to establish a link, and explains the commands and their use. For
further information, refer to the Cisco Broadband Fixed Wireless Site Planning Guide.
Prerequisites
Requirements
Before you configure a wireless modem card, you must have this information:
Number of antennas
•
End of the communication link to be designated as "master"
•
Transmit and receive frequencies
•
IP address and subnet mask of the wireless modem card
•
Transmit power
•
Intermediate frequency (IF) cable loss between the wireless modem card and each wireless transverter
(including loss in the power feed panel)
(including loss in the power feed panel)
•
Components Used
The information in this document is based on these software and hardware versions:
Cisco uBR7200 Series Universal Broadband Router
•
Wireless Modem Card
•