Cisco Cisco Gigabit Ethernet Switch Module (CGESM) for HP 技术参考
2-78
Cisco Gigabit Ethernet Switch Module for the HP p-Class BladeSystem Command Reference Guide
380265-002
Chapter 2 CGESM Switch Cisco IOS Commands
dot1x max-req
dot1x max-req
Use the dot1x max-req interface configuration command to set the maximum number of times that the
switch sends an Extensible Authentication Protocol (EAP) frame from the authentication server
(assuming that no response is received) to the client before restarting the authentication process. Use the
no form of this command to return to the default setting.
switch sends an Extensible Authentication Protocol (EAP) frame from the authentication server
(assuming that no response is received) to the client before restarting the authentication process. Use the
no form of this command to return to the default setting.
dot1x max-req count
no dot1x max-req
Syntax Description
Defaults
The default is 2 times.
Command Modes
Interface configuration
Command History
Usage Guidelines
You should change the default value of this command only to adjust for unusual circumstances such as
unreliable links or specific behavioral problems with certain clients and authentication servers.
unreliable links or specific behavioral problems with certain clients and authentication servers.
Examples
This example shows how to set 5 as the number of times that the switch sends an EAP frame from the
authentication server to the client before restarting the authentication process:
authentication server to the client before restarting the authentication process:
Switch(config-if)# dot1x max-req 5
You can verify your settings by entering the show dot1x [interface interface-id] privileged EXEC
command.
command.
Related Commands
count
Number of times that the switch resends an EAP frame from the authentication
server before restarting the authentication process. The range is 1 to 10.
server before restarting the authentication process. The range is 1 to 10.
Release
Modification
12.2(25)SE1
This command was introduced.
Command
Description
tx-period
Sets the number of seconds that the switch waits for a response to an
EAP-request/identity frame from the client before resending the
request.
EAP-request/identity frame from the client before resending the
request.
[interface
interface-id]
Displays IEEE 802.1x status for the specified port.