Cisco Cisco Gigabit Ethernet Switch Module (CGESM) for HP 技术参考
2-81
Cisco Gigabit Ethernet Switch Module for the HP p-Class BladeSystem Command Reference Guide
380265-002
Chapter 2 CGESM Switch Cisco IOS Commands
dot1x port-control
•
EtherChannel port—Do not configure a port that is an active or a not-yet-active member of an
EtherChannel as an IEEE 802.1x port. If you try to enable IEEE 802.1x on an EtherChannel port,
an error message appears, and IEEE 802.1x is not enabled.
EtherChannel as an IEEE 802.1x port. If you try to enable IEEE 802.1x on an EtherChannel port,
an error message appears, and IEEE 802.1x is not enabled.
•
Switched Port Analyzer (SPAN) and Remote SPAN (RSPAN) destination ports—You can enable
IEEE 802.1x on a port that is a SPAN or RSPAN destination port. However, IEEE 802.1x is disabled
until the port is removed as a SPAN or RSPAN destination. You can enable IEEE 802.1x on a SPAN
or RSPAN source port.
IEEE 802.1x on a port that is a SPAN or RSPAN destination port. However, IEEE 802.1x is disabled
until the port is removed as a SPAN or RSPAN destination. You can enable IEEE 802.1x on a SPAN
or RSPAN source port.
To globally disable IEEE 802.1x on the switch, use the no dot1x system-auth-control global
configuration command. To disable IEEE 802.1x on a specific port, use the no dot1x port-control
interface configuration command.
configuration command. To disable IEEE 802.1x on a specific port, use the no dot1x port-control
interface configuration command.
Examples
This example shows how to enable IEEE 802.1x on a port:
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# dot1x port-control auto
You can verify your settings by entering the show dot1x [interface interface-id] privileged EXEC
command.
command.
Related Commands
Command
Description
[interface interface-id]
Displays IEEE 802.1x status for the specified port.