Cisco Cisco Firepower Management Center 2000 發佈版本通知
15
FireSIGHT System Release Notes
Version 5.3.1.1
Uninstalling the Update
Note
Do not use the shell to update a fresh, unconfigured (Version 5.3.1.1) installation of the FireSIGHT
System. Before you update an appliance using the shell, make sure that you complete its initial setup
using its web interface.
System. Before you update an appliance using the shell, make sure that you complete its initial setup
using its web interface.
For the Version 5.3.1.1 update, all appliances reboot. Depending on how your devices are configured and
deployed, the update process may also affect traffic flow and link state. For more information, see
deployed, the update process may also affect traffic flow and link state. For more information, see
.
To install the update using the shell:
Step 1
Read these release notes and complete any required pre-update tasks.
For more information, see
.
Step 2
Download the appropriate update from the Support site:
•
for Series 2 Defense Centers:
Sourcefire_3D_Defense_Center_Patch-5.3.1.1-37.sh
•
for Series 3 and virtual Defense Centers:
Sourcefire_3D_Defense_Center_S3_Patch-5.3.1.1-37.sh
•
for ASA FirePOWER devices:
Cisco_Network_Sensor_Patch-5.3.1.1-33.sh
Note
Download the update directly from the Support site. If you transfer an update file by email, it may
become corrupted.
become corrupted.
Step 3
Log into the appliance's shell using an account with Administrator privileges.
Step 4
Note that on a Series 3 or virtual ASA FirePOWER device, you must type
expert
to display the shell
prompt.At the prompt, run the update as the root user, providing your password when prompted:
sudo install_update.pl /var/sf/updates/update_name
where
update_name
is the file name of the update you downloaded earlier.
The update process begins.
Step 5
When the update is complete, the appliance reboots. You can monitor the update and complete any
post-update steps as described in the following sections:
post-update steps as described in the following sections:
–
–
Uninstalling the Update
The following sections help you uninstall the Version 5.3.1.1 update from your appliances:
•
•
•