Cisco Cisco Firepower Management Center 2000 發佈版本通知

1

www.cisco.com

Firepower System Release Notes for 

Version 6.0.0 Pre-Install

The Version 6.0.0 Pre-Install must be installed on Firepower Management Centers and managed devices that have STIG 
enabled via prior to updating your system to Version 6.0.0. This Pre-Install optimizes the update procedure for Firepower 
Management Centers updating to Version 6.0.0 and decreases the time the update takes to complete. Once you install 
the Version 6.0.0 Pre-Install, update the system to Version 6.0.0. For more information, see the Firepower System 
Release Notes Version 6.0.0.

These notes provide installation instructions and a summary of the caveats resolved by the Firepower System Version 
6.0.0 Pre-Install.

For more information, see the following sections:













Before You Begin: Important Update Notes

Apply the Pre-Install to appliances running the following versions:



Firepower Management Centers running Version 5.4.1.1 or later

The Version 6.0.0 Pre-Install optimizes updating Firepower Management Centers to Version 6.0.0 and decreases 

the time the update takes to complete.



Series 3 devices running Version 5.4.0.2, Version 5.4.0.3, Version 5.4.0.4, Version 5.4.0.5, or Version 5.4.0.6



ASA FirePOWER modules (ASA5512-X, ASA5515-X, ASA5525-X, ASA5545-X, ASA5555-X, ASA5585-X-SSP-10, 
ASA5585-X-SSP-20, ASA5585-X-SSP-40, and the ASA5585-X-SSP-60) running Version 5.4.0.2, Version 5.4.0.3, 
Version 5.4.0.4, Version 5.4.0.5, or Version 5.4.0.6



ASA FirePOWER modules (ASA5506-X, ASA5506W-X, ASA5506H-X, ASA5508-X, and ASA5516-X) running 
Version 5.4.1.1, Version 5.4.1.2, Version 5.4.1.3, Version 5.4.1.4, or Version 5.4.1

 The Version 6.0.0 Pre-Install and Version 6.0.0 and later do not support Series 2 devices.

The Pre-Install is not required on appliances running the following versions: