Cisco Cisco Firepower Management Center 2000 安装指南
Installing the Firepower Management Center
Firepower Management Center Getting Started Guide
7
—
3.
When you are finished, click
Apply
.
The Management Center is configured according to your selections. You are logged into the web interface as
the
the
admin
user, which has the Administrator role.
Note:
If you connected directly to the device using an Ethernet cable, disconnect the computer and connect
the Management Center’s management interface to the management network. Use a browser on a computer
on the management network to access the Management Center at the IP address or host name that you just
configured, and complete the rest of the procedures in this guide.
on the management network to access the Management Center at the IP address or host name that you just
configured, and complete the rest of the procedures in this guide.
4.
Use the Task Status page (
System > Monitoring > Task Status
) to verify that the initial setup was successful.
The page auto-refreshes every ten seconds. Monitor the page until it lists a status of
Completed
for the initial
device registration and policy apply tasks. If, as part of setup, you configured an intrusion rule or geolocation
update, you can also monitor those tasks.
update, you can also monitor those tasks.
The Management Center is ready to use. See the Firepower Management Center Configuration Guide for more
information on configuring your deployment.
information on configuring your deployment.
What to Do Next
.
Setup Options
Change Password
You must change the password for the
admin
account. This account has Administrator privileges and cannot be
deleted.
Cisco recommends that you use a strong password that is at least eight alphanumeric characters of mixed case
and includes at least one numeric character. Avoid using words that appear in a dictionary.
and includes at least one numeric character. Avoid using words that appear in a dictionary.
Network Settings
A Management Center’s network settings allow it to communicate on your management network. If you already
configured the network settings, this section of the page may be prepopulated.
configured the network settings, this section of the page may be prepopulated.
The Firepower System provides a dual stack implementation for both IPv4 and IPv6 management environments.
You must specify the management network protocol (
You must specify the management network protocol (
IPv4
,
IPv6
, or
Both
). Depending on your choice, the setup page
displays various fields where you must set the IPv4 or IPv6 management IP address, netmask or prefix length, and
default gateway:
default gateway:
For IPv4, you must set the address and netmask in dotted decimal form (for example: a netmask of
255.255.0.0).
255.255.0.0).
For IPv6 networks, you can select the
Assign the IPv6 address using router autoconfiguration
check box to
automatically assign IPv6 network settings. Otherwise, you must set the address in colon-separated
hexadecimal form and the number of bits in the prefix (for example: a prefix length of 112).
hexadecimal form and the number of bits in the prefix (for example: a prefix length of 112).
You can also specify up to three DNS servers, as well as the host name and domain for the device.
Time Settings
You can set the time for a Management Center either manually or via network time protocol (NTP) from an NTP
server.
server.
You can also specify the time zone used on the local web interface for the
admin
account. Click the current time
zone to change it using a pop-up window.