Cisco Cisco IOS Software Release 12.4(11)T
Symmetrical RTP Support for MGCP-Based Calls
Configuration Examples for Symmetrical RTP Support for MGCP-Based Calls
8
Cisco IOS Release 12.4(11)T
Examples
The following example forces the MGCP gateway to place the direction attribute in the SDP:
Router# conf t
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)# mgcp behavior comedia-sdp-force enable
Router(config)# exit
Troubleshooting Tips
•
Use the show mgcp command to verify feature configuration.
The following sample output displays the status of media source checking and the gateway role.
Router# show mgcp
MGCP Admin State ACTIVE, Oper State ACTIVE - Cause Code NONE
MGCP call-agent: 7.7.0.201 2497 Initial protocol service is MGCP 1.0
.
.
.
MGCP Dynamic payload type for NTE is 99
MGCP rsip-range is enabled for TGCP only.
MGCP Comedia role is PASSIVE
MGCP Comedia check media source is ENABLED
MGCP Comedia sdp force is DISABLED
MGCP Guaranteed scheduler time is DISABLED
MGCP DNS stale threshold is 30 seconds
.
.
.
•
debug mgcp media—shows address and port detection. Used to determine if source address and
port has been detected for the call.
port has been detected for the call.
•
debug mgcp packet—shows MPCP messages and SDP contents. Used to see remote SDP and local
SDP. Verify the direction attribute in each.
SDP. Verify the direction attribute in each.
•
Make a call in the NAT network, one in the CPE to Public direction and one in the Public to CPE
direction. Verify two-way voice is heard in both scenarios. Alternately, verify SDP direction
attribute and source port/address dection using MGCP debugs.
direction. Verify two-way voice is heard in both scenarios. Alternately, verify SDP direction
attribute and source port/address dection using MGCP debugs.
Configuration Examples for Symmetrical RTP Support for
MGCP-Based Calls
MGCP-Based Calls
This section provides the following configuration examples:
•
•