Cisco Cisco IOS Software Release 12.2(35)SE 發佈版本通知
Americas Headquarters:
© 2010 Cisco Systems, Inc. All rights reserved.
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Release Notes for the Cisco Catalyst
Blade Switch 3040 for FSC,
Cisco IOS Release 12.2(50)SE and Later
Blade Switch 3040 for FSC,
Cisco IOS Release 12.2(50)SE and Later
Revised October 5, 2010
Cisco IOS Release 12.2(50)SE and later runs on the Cisco Catalyst Blade Switch 3040 for FSC, referred
to as the switch. The switch is installed in the Fujitsu Siemens Computers (FSC) PRIMERGY BX600
system, referred to as the BX600 system.
to as the switch. The switch is installed in the Fujitsu Siemens Computers (FSC) PRIMERGY BX600
system, referred to as the BX600 system.
Unless otherwise noted, the term switch refers to a standalone switch.
Note
Before you install the switch in the BX600 system, upgrade the BX600 system management software to
version 1.68 or later for the switch to operate properly.
version 1.68 or later for the switch to operate properly.
Check for updates to this document at this URL for information about compatibility with the BX600
system software:
system software:
Note
If you wish to use Device Manager to upgrade the switch from Cisco IOS Release 12.2(35)SE through
Cisco IOS Release 12.2(40)SE1 (the LAN Base image) to Cisco IOS Release 12.2(50)SE or later (the IP
base image), you must first upgrade to Cisco IOS Release 12.2(40)SE2.
Cisco IOS Release 12.2(40)SE1 (the LAN Base image) to Cisco IOS Release 12.2(50)SE or later (the IP
base image), you must first upgrade to Cisco IOS Release 12.2(40)SE2.
These release notes include important information about Cisco IOS Release 12.2(50)SE and later and
any limitations, restrictions, and caveats that apply to them. Verify that these release notes are correct
for your switch:
any limitations, restrictions, and caveats that apply to them. Verify that these release notes are correct
for your switch:
•
If you are installing a new switch, see the Cisco IOS release label on the switch packaging.
•
If your switch is on, use the show version privileged EXEC command. See the
•
If you are upgrading to a new release, see the software upgrade filename for the software version.
See the
See the