Cisco Cisco Aironet 1522 Lightweight Outdoor Mesh Access Point 安装指南

This declaration is only valid for configurations (combinations of software, firmware and hardware) 
provided and/or supported by Cisco Systems. The use software or firmware not supported/provided 
by Cisco Systems may result that the equipment is no longer compliant with the regulatory 
requirements. 

Safety warnings appear throughout this guide in procedures that may harm you if performed 
incorrectly. A warning symbol precedes each warning statement. The warnings below are general 
warnings that are applicable to the entire guide. Specific warnings are included in the sections to which 
they apply.

Translated versions of the safety warnings in this guide are provided in the Safety Warnings for 
Cisco Aironet 1520 Series Outdoor Mesh Access Points document that accompanies this guide. 
The translated warnings are also in Appendix A of the Cisco Aironet 1520 Series Outdoor Mesh 
Access Point Hardware Installation Guide, which is available at cisco.com.

This warning symbol means danger. You are in a situation that could cause bodily injury. 
Before you work on any equipment, be aware of the hazards involved with electrical 
circuitry and be familiar with standard practices for preventing accidents. Use the 
statement number provided at the end of each warning to locate its translation in the 
translated safety warnings that accompanied this device. 
Statement 1071
SAVE THESE INSTRUCTIONS

There is the danger of explosion if the battery is replaced incorrectly. Replace the battery 
only with the same or equivalent type recommended by the manufacturer. Dispose of 
used batteries according to the manufacturer’s instructions. Statement 1015

Do not operate the unit near unshielded blasting caps or in an explosive environment 
unless the device has been modified to be especially qualified for such use. 
Statement 364