Cisco Cisco ASA for Nexus 1000V Series Switch 技术手册

ASA File Transfer with FXP Configuration Example

Document ID: 118306

Contributed by Deepika Mahankali, Cisco TAC Engineer.
Aug 21, 2014

Contents

Introduction
Prerequisites
Requirements
Components Used
Background Information
Mechanism of File Transfer Via FXP
FTP Inspection and FXP
Configure
Network Diagram
Configure the ASA Via CLI
Verify
File Transfer Process
Troubleshoot
FTP Inspection Disabled Scenario
FTP Inspection Enabled

Introduction

This document describes how to configure File eXchange Protocol (FXP) on the Cisco Adaptive Security
Appliance (ASA) via the CLI.

Prerequisites

Requirements

Cisco recommends that you have basic knowledge of File Transfer Protocol (FTP) (Active/Passive modes).

Components Used

The information in this document is based on the Cisco ASA that runs software Versions 8.0 and later.

Note: This configuration example uses two Microsoft Windows workstations that act as FXP servers and run
FTP services (3C Daemon). They also have FXP enabled. Another Microsoft Windows workstation that runs
FXP client software (FTP Rush) is also used.

The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.