Cisco Cisco Email Security Appliance X1070 故障排查指南

ESA FAQ: How do you import a configuration file
into a new appliance?

Document ID: 117841

Contributed by Phillip Rosson and Robert Sherwin, Cisco TAC
Engineers.
Jun 25, 2014

Contents

Introduction
Prerequisites
Requirements
Components Used
How do you import a configuration file into a new appliance?

Introduction

This document describes how to import a current Cisco Email Security Appliance (ESA) configuration file
into a new appliance when a replacement is required.

Prerequisites

Requirements

Cisco recommends that you have knowledge of the Cisco ESA.

Components Used

The information in this document is based on the Cisco ESA that runs AsyncOS Versions 7.1.x and later.

The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.

Note: This document assumes that both of the appliances run the same AsyncOS version.

How do you import a configuration file into a new
appliance?

Complete these steps in order to save the current configuration file:

Navigate to System Administration > Configuration File on the current ESA.

Select Download file to local computer in order to view or save the file.

Uncheck the Mask passwords check box under Configuration Files.