Cisco Cisco 5508 Wireless Controller 技术参考

AP Model......................................... AIR-CAP3602I-S-K9   

AP Image......................................... C3600-K9W8-M

IOS Version...................................... 15.2(20130107:162741)$

Reset Button..................................... Enabled

AP Serial Number................................. FGL1552P0AY

AP Certificate Type.............................. Manufacture Installed

AP User Mode..................................... AUTOMATIC

AP User Name..................................... Not Configured

AP Dot1x User Mode............................... Not Configured

AP Dot1x User Name............................... Not Configured

Cisco AP system logging host..................... 255.255.255.255

AP Up Time....................................... 0 days, 03 h 39 m 44 s

AP LWAPP Up Time................................. 0 days, 01 h 33 m 22 s

Join Date and Time............................... Mon Feb  4 02:05:42 2013

Join Taken Time.................................. 0 days, 02 h 06 m 21 s

GPS Present...................................... NO

Ethernet Vlan Tag................................ Disabled

Ethernet Port Duplex............................. Auto

Ethernet Port Speed.............................. Auto

AP Link Latency.................................. Disabled

Rogue Detection.................................. Enabled

AP TCP MSS Adjust................................ Disabled

Hotspot Venue Group.............................. Residential

Hotspot Venue Type............................... Hotel or Motel

Venue Name in 'eng' language..................... 'Hotel Lux'

      DNS server IP ............................. Not Available

(Cisco Controller) >config rogue detection enable ?

all                    Applies the configuration to all connected APs.

<Cisco AP>     Enter the name of the Cisco AP.

A local mode AP scans only country channels/DCA channels depending on the configuration. If the 
rogue is in any other channel, the controller will not be able to identify the rogue if you do not have 
monitor mode APs in the network. Issue this command in order to verify:

(Cisco Controller) >show advanced 802.11a monitor

Default 802.11a AP monitoring

  802.11a Monitor Mode........................... enable

  802.11a Monitor Mode for Mesh AP Backhaul...... disable

  802.11a Monitor Channels....................... Country channels

  802.11a RRM Neighbor Discover Type............. Transparent

  802.11a AP Coverage Interval................... 180 seconds

  802.11a AP Load Interval....................... 60 seconds

  802.11a AP Noise Interval...................... 180 seconds

  802.11a AP Signal Strength Interval............ 60 seconds

  802.11a AP Neighbor Report Interval............ 180 seconds