Cisco Cisco Email Security Appliance C690 用户指南
A-2
Cisco AsyncOS 8.0.2 for Email User Guide
Appendix A Accessing the Appliance
IP Interfaces
Configuring FTP Access to the Email Security appliance
Procedure
Step 1
Use the Network > IP Interfaces page or the
interfaceconfig
command to enable FTP access for the
interface.
WARNING:
By disabling services via the
interfaceconfig
command, you have the potential to
disconnect yourself from the CLI, depending on how you are connected to the appliance. Do not disable
services with this command if you are not able to reconnect to the appliance using another protocol, the
Serial interface, or the default settings on the Management port.
services with this command if you are not able to reconnect to the appliance using another protocol, the
Serial interface, or the default settings on the Management port.
In this example, the Management interface is edited to enable FTP access on port 21 (the default
port):
port):
Figure A-1
Edit IP Interface Page
Note
Remember to
commit
your changes before moving on to the next step.
Step 2
Access the interface via FTP. Ensure you are using the correct IP address for the interface. For example:
Note
Many browsers also allow you to access interfaces via FTP.
Step 3
Browse to the directory for the specific task you are trying to accomplish. After you have accessed an
interface via FTP, you can browse the following directories to copy and add (“GET” and “PUT”) files.
See the following table.
interface via FTP, you can browse the following directories to copy and add (“GET” and “PUT”) files.
See the following table.
$ ftp 192.168.42.42