Cisco Cisco Email Security Appliance X1070 用户指南
Chapter 3 Setup and Installation
3-28
Cisco IronPort AsyncOS 7.5 for Email Configuration Guide
OL-25136-01
When you configure an interface to relay outbound mail, the System Setup Wizard
turns on SSH for the interface as long as no public listeners are configured to use
the interface.
turns on SSH for the interface as long as no public listeners are configured to use
the interface.
In the following example, two interfaces are created:
•
192.168.42.42 remains configured on the Management interface.
•
192.168.1.1 is enabled on the Data 1 Ethernet interface. It is configured to
accept mail for domains ending in .example.com and an SMTP route is
defined for exchange.example.com.
accept mail for domains ending in .example.com and an SMTP route is
defined for exchange.example.com.
•
192.168.2.1 is enabled on the Data 2 Ethernet interface. It is configured to
relay mail from exchange.example.com.
relay mail from exchange.example.com.
Note
The following example pertains to X1000/1050/1060/1070,
C60/600/650/660/670, and C30/300/350/360/370 appliances. For
C10/100/150/160 appliances, the Data 2 interface is typically configured for both
incoming and outgoing mail while the Data 1 interface is used for appliance
management (see
C60/600/650/660/670, and C30/300/350/360/370 appliances. For
C10/100/150/160 appliances, the Data 2 interface is typically configured for both
incoming and outgoing mail while the Data 1 interface is used for appliance
management (see
).