Cisco Cisco Email Security Appliance C190 用户指南
3-10
User Guide for AsyncOS 9.8 for Cisco Email Security Appliances
Chapter 3 Setup and Installation
Preparing for System Setup
Choosing Network Connections to Receive and Deliver Email
Most users take advantage of the two Data Ethernet ports on the Email Security appliance by connecting
to two networks from the appliance:
to two networks from the appliance:
•
The private network accepts and delivers messages to your internal systems.
•
The public network accepts and delivers messages to the Internet.
Other users may want to use only one Data port serving both functions. Although the Management
Ethernet port can support any function, it is preconfigured for access to the graphical user interface and
the command line interface.
Ethernet port can support any function, it is preconfigured for access to the graphical user interface and
the command line interface.
Binding Logical IP Addresses to Physical Ethernet Ports
You can segregate incoming and outgoing email traffic over separate listeners and on separate IP
addresses. You can use Internet Protocol version 4 (IPv4) and version 6 (IPv6) addresses. However, the
System Setup Wizard on the appliance supports initial configuration of the following configurations:
addresses. You can use Internet Protocol version 4 (IPv4) and version 6 (IPv6) addresses. However, the
System Setup Wizard on the appliance supports initial configuration of the following configurations:
•
2 separate listeners on 2 logical IPv4 and 2 IPv6 addresses configured on separate physical
interfaces
interfaces
–
segregates incoming and outgoing traffic
–
you can assign an IPv4 and an IPv6 address to each listener
•
1 listener on 1 logical IPv4 address configured on one physical interface
–
combines both incoming and outgoing traffic
–
you can assign both an IPv4 and an IPv6 address to the listener
The Email Security appliance can support both IPv4 and IPv6 addresses on single listener. The listener
will accept mail on both the addresses. All settings on a listener apply to both IPv4 and IPv6 addresses.
will accept mail on both the addresses. All settings on a listener apply to both IPv4 and IPv6 addresses.
Choosing Network Settings for Your Connections
You will need the following network information about each Ethernet port that you choose to use:
•
IP address (IPv4 or IPv6 or both)
•
Netmask for IPv4 address in CIDR format
•
Prefix for IPv6 address in CIDR format
In addition, you will need the following information about your overall network:
•
IP address of the default router (gateway) on your network
•
IP address and hostname of your DNS servers (not required if you want to use Internet root servers)
•
Hostname or IP address of your NTP servers (not required if you want to use Cisco’s time servers)
See
for more information.
Note
If you are running a firewall on your network between the Internet and the Email Security appliance, it
may be necessary to open specific ports for the appliance to work properly. See
may be necessary to open specific ports for the appliance to work properly. See
for more information.