Cisco Cisco NAC Appliance 4.8.4 技术手册
NAC: Configure the LDAP Over SSL on the Clean
Access Manager (CAM)
Access Manager (CAM)
Document ID: 107322
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Configure
Steps to Configure LDAP over SSL on CAM
Verify
Troubleshoot
Related Information
Prerequisites
Requirements
Components Used
Conventions
Configure
Steps to Configure LDAP over SSL on CAM
Verify
Troubleshoot
Related Information
Introduction
This document describes how to configure the Lightweight Directory Access Protocol (LDAP) over SSL on
the Clean Access Manager (CAM).
the Clean Access Manager (CAM).
Prerequisites
Requirements
This configuration is applicable to the CAM version 3.5 and later.
Components Used
The information in this document is based on the Clean Access Manager version 4.1.
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Conventions
Refer to the Cisco Technical Tips Conventions for more information on document conventions.
Configure
In this section, you are presented with the information to configure the features described in this document.
Note: Use the Command Lookup Tool (registered customers only) in order to obtain more information on the
commands used in this section.
commands used in this section.