Cisco Cisco Aironet 340 Ethernet Bridges 發佈版本通知

In the Value column, click Browse. Find the local drive where you saved the new firmware version and 
select the firmware file.

Click Send. The new firmware is loaded and the bridge or access point reboots.

This section describes new features in firmware version 8.65, which are also included in version 8.65_2.

If you forget the password that allows you to configure the bridge or access point through the console 
port, you might need to completely reset the configuration. Follow these steps to delete the current 
configuration and return all settings to the factory defaults:

Use a straight-through cable with 9-pin male to 9-pin female connectors to connect the COM 1 or COM 
2 port on your computer to the RS-232 port on the bridge or access point. You can select the Reset 
option only through the console port.

Open a terminal-emulation program on your computer.

These instructions describe HyperTeminal; other programs are similar.

In the Connection Description window, enter a name and select an icon for the connection and click 
OK. 

In the Connect To window, select the port to which the cable is connected and click OK. 

In the Port Settings window, enter the following settings: 

9600 baud, 

8 data bits, 

No parity, 

1 stop bit, and 

Xon/Xoff flow control

Click OK and press Enter.

When the Main Menu screen appears, reboot the bridge or access point by turning the unit off and then 
turning it back on.

When the bridge or access point reboots and the Main Menu screen reappears, type 2 to select Reset and 
press Enter.

The Reset option appears only if you enable password protection for console write privileges.

Type yes and press Enter to confirm the command.