Cisco Cisco SG500-52PP 52-port Gigabit Max PoE+ Stackable Managed Switch 技术参考
CDP Commands
OL-31486-02 Command Line Interface Reference Guide
227
8
Ethernet gi1/1/3 is down
Example 4 - In this example, CDP is globally enabled and enabled on the port,
which is up and information is displayed.
which is up and information is displayed.
switchxxxxxx#
show cdp tlv interface gi1/1/1
cdp globally is enabled
Capability Codes: R - Router,T - Trans Bridge, B - Source Route Bridge
S - Switch, H - Host, I - IGMP, r - Repeater,
P - VoIP Phone,M - Remotely-Managed Device,
C - CAST Phone Port, W - Two-Port MAC Relay
Interface TLV: gi1/1/1
CDP is enabled
Ethernet gi1/1/1 is up,
Device ID TLV: type is MAC address; Value is 00:11:22:22:33:33:44:44
Address TLV: IPv4: 1.2.2.2 IPv6:
Port_ID TLV: gi1/1/1
Capabilities: S, I
Version TLV: 1 and 2
Platform TLV: VSD Ardd
Native VLAN TLV: 1
Full/Half Duplex TLV: full-duplex
Appliance VLAN_ID TLV: Appliance-ID is 1; VLAN-ID is 100
COS for Untrusted Ports TLV: 1
sysName: a-switch
Power Available TLV: Request-ID is 1 Power management-ID is 1;
Available-Power is 10;
Management-Power-Level is 0xFFFFFFFF
Example 5 - In this example, CDP is globally enabled, and no ports are specified,
so information is displayed for all ports on which CDP is enabled who are up.
so information is displayed for all ports on which CDP is enabled who are up.
switchxxxxxx#
show cdp tlv interface