Cisco Cisco Packet Data Gateway (PDG) 故障排查指南
CSCF Serving-CSCF Configuration Mode Commands
▀ authentication
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22948-01
Specifies that authentication is based on the AoR when accessing the S-CSCF service.
Specifies that the MD5 algorithm is used as the authentication type for accessing the S-CSCF service.
specifies a preference - the lower the value, the higher the preference.
must be an integer from 1 to
1000.
Important:
In order to change a priority level, you must remove the original value and configure a new one.
Disables the specified authentication method for the S-CSCF service.
Usage
Use this command to configure the authentication method used by the S-CSCF service.
Important:
The S-CSCF supports multiple authorization schemes, but this requires disabling all authorization
configured in the S-CSCF service so that it will send ―Unknown‖ in the Sip-Authorization-Scheme AVP. This allows
the HSS to dictate authorization. The following commands disable all authorization configured in the S-CSCF service to
allow HSS to control authorization:
the HSS to dictate authorization. The following commands disable all authorization configured in the S-CSCF service to
allow HSS to control authorization:
Example
The following command configures the authentication method used by the S-CSCF service to MD5 with a preference of
The following command configures the authentication method used by the S-CSCF service to MD5 with a preference of
: