Cisco Cisco Packet Data Gateway (PDG) 故障排查指南
CSCF Service Configuration Mode Commands
▀ access-type
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
Associates an access type with a CSCF access profile. Different access types can refer to the same access
profile.
profile.
Configures UE IP address/range for a specific access type.
must be from 1 to 79 alpha and/or numeric characters.
: Specifies a combined IP address subnet mask bits to indicate what IP
addresses the specific access-type applies to.
must be specified using the form ―IP
Address/Mask Bits‖ where the IP address must be expressed in dotted decimal notation for IPv4 or colon
notation for IPv6, and the mask bits are a numeric value, which is the number of bits in the subnet mask.
notation for IPv6, and the mask bits are a numeric value, which is the number of bits in the subnet mask.
: Configure UE IP range for specific access-type.
specifies the beginning of the range of addresses.
specifies the end of the range of addresses .
must be expressed in dotted decimal notation for IPv4 or colon notation for IPv6.
Removes the specified access type from a CSCF access profile or UE IP address/range.
Usage
Use this command to associated the access types for a specified CSCF access profile or UE IP address/range
name.
name.
Important:
Use the
command to enable SIP P-Access-Network-Info (PANI) header insertion.
CSCF Proxy-CSCF Configuration Mode commands are defined in the CSCF Proxy-CSCF Configuration Mode
Commands chapter in this guide.
Commands chapter in this guide.
Example
The following command identifies the access type adsl and assigns it to access profile
The following command identifies the access type adsl and assigns it to access profile
: