Cisco Cisco Packet Data Gateway (PDG)
Use this command to configure the cause code returned to a UE when a VLR unreachable condition is present.
To set the cause codes for situations where a call control profile cannot be attached to a call (for example
new-call restrictions, congestion during new call attempt, etc.), use the local-cause-code-mapping command
in the mme-service configuration mode. This command is described in the MME Service Configuration Mode
Commands chapter.
new-call restrictions, congestion during new call attempt, etc.), use the local-cause-code-mapping command
in the mme-service configuration mode. This command is described in the MME Service Configuration Mode
Commands chapter.
Examples
The following command maps the "network failure" EMM cause code to the VLR unreachable condition:
local-cause-code-mapping vlr-unreachable emm-cause-code network-failure
Command Line Interface Reference, Modes C - D, StarOS Release 19
154
Call Control Profile Configuration Mode
local-cause-code-mapping vlr-unreachable