Cisco Cisco Packet Data Gateway (PDG)
any
Matches any prefix.
network_address/net_mask [ ge ge_value ] [ le le_value ]
Specifies the prefix to match.
network_address/net_mask: the IP address and the length, in bits, of the network mask that defines the prefix.
The IP address and mask must be entered in IPv4dotted-decimal notation. When neither ge (greater than or
equal to) or le (less than or equal to) are specified an exact match is assumed.
The IP address and mask must be entered in IPv4dotted-decimal notation. When neither ge (greater than or
equal to) or le (less than or equal to) are specified an exact match is assumed.
ge ge_value: Specifies the minimum prefix length to match as an integer from 0 through 32. If only the ge
value is specified, the range is from the ge value to 32. The ge value must be greater than net_mask and less
than the le value.
value is specified, the range is from the ge value to 32. The ge value must be greater than net_mask and less
than the le value.
le le_value: Specifies the maximum prefix length to match as an integer from 0 through 32. If only the le
value is specified, the range is from the net_mask to the le value. The le value must be less than or equal to
32.
value is specified, the range is from the net_mask to the le value. The le value must be less than or equal to
32.
The following equation describes the conditions that ge and le values must satisfy:
net_mask < ge_value < le_value <= 32
Usage Guidelines
Use this command to filter routes by their IP prefix.
Examples
ip prefix-list name prelist10 seq 5 permit 192.168.100.0/8 ge 12 le 24
Command Line Interface Reference, Modes C - D, StarOS Release 19
727
Context Configuration Mode Commands I-M
ip prefix-list