Cisco Cisco Packet Data Gateway (PDG)
1's in the resulting mask indicate the corresponding bit in the IP address is significant in determining the
network.
network.
gateway_ip_address | next-hop next_hop_ip_address | point-to-point | tunnel
Specifies which device or network to use when forwarding packets.
gateway_ip_address: Specifies the IP address of the network gateway to which to forward packets. The address
must be entered in IPv4 dotted-decimal notation (###.###.###.###).
must be entered in IPv4 dotted-decimal notation (###.###.###.###).
next-hop next_hop_ip_address: Specifies the next-hop IP address to which packets are to be forwarded. The
address must be entered in IPv4 dotted-decimal notation.
address must be entered in IPv4 dotted-decimal notation.
point-to-point: Specifies that the egress port is an ATM point-to-point interface.
tunnel: Sets the static route for this egress interface as tunnel type, such as IPv6-over-IPv4 or GRE.
egress_intrfc_name
Specifies the name of the egress (out-bound) interface name in the current context as an alphanumeric string
of 1 through 79 characters.
of 1 through 79 characters.
cost cost
Specifies the relative cost of the route. cost must be an integer from 0 through 255 where 255 is the most
expensive. Default: 0
expensive. Default: 0
fall-over bfd multihop mhsess_name
Enables fall-over BFD functionality for the specified multihop session. The fall-over bfd option uses BFD
to monitor neighbor reachability and liveliness. When enabled it will tear down the session if BFD signals a
failure. Specify mhsess_name as an alphanumeric string of 1 through 19 characters.
to monitor neighbor reachability and liveliness. When enabled it will tear down the session if BFD signals a
failure. Specify mhsess_name as an alphanumeric string of 1 through 19 characters.
precedence precedence
Specifies the selection order precedence for this routing information. precedence must be an integer from 1
through 254 where 1 is the highest precedence. Default: 1
through 254 where 1 is the highest precedence. Default: 1
vrf vrf_name
Associates a Virtual Routing and Forwarding (VRF) context with this static route configuration.
vrf_name is the name of a preconfigured VRF context configured in Context Configuration Mode via the ip
vrf command.
vrf command.
static bfd if_name remote-endpt_ipv4_address
Creates a static IP route that will be associated with Bidirectional Forwarding Detection (BFD). For additional
information, see the BFD Configuration Mode Commands chapter.
information, see the BFD Configuration Mode Commands chapter.
if_name: Specifies the name of the interface to which the static BFD neighbor is bound as an alphanumeric
string of 1 through 79 characters.
string of 1 through 79 characters.
remote_endpt_ipv4_address: Specifies the gateway address of the BFD neighbor in IPv4 dotted-decimal
notation.
notation.
Command Line Interface Reference, Modes C - D, StarOS Release 19
730
Context Configuration Mode Commands I-M
ip route