Cisco Cisco ASR 5000
GGSN Service Configuration Mode Commands
▀ gtpc map-mbr-ambr
▄ Command Line Interface Reference, StarOS Release 18
5238
gtpc map-mbr-ambr
This command maps the Maximum Bit Rate AVP received in Update PDP Context QoS message from SGSN to
Aggregate Maximum Bit Rate attribute value (AMBR), if AMBR is not received in Update PDP Context QoS message
from SGSN. This command is applicable for Gn-Gp GGSN mode only and not applicable to standalone GGSN. By
default this command is disabled.
Aggregate Maximum Bit Rate attribute value (AMBR), if AMBR is not received in Update PDP Context QoS message
from SGSN. This command is applicable for Gn-Gp GGSN mode only and not applicable to standalone GGSN. By
default this command is disabled.
Product
GGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > GGSN Service Configuration
configure > context context_name > ggsn-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ggsn-service)#
Syntax
[ default | no ] gtpc map-mbr-ambr
default
Sets the default mode to map the Maximum Bit Rate AVP received in Update PDP Context QoS message
from SGSN to Aggregate Maximum Bit Rate attribute value (AMBR), if AMBR is not received in Update
PDP Context QoS message from SGSN.
from SGSN to Aggregate Maximum Bit Rate attribute value (AMBR), if AMBR is not received in Update
PDP Context QoS message from SGSN.
no
Removes the configured mapping of the MBR AVP received in Update PDP Context message from SGSN to
AMBR attribute value.
AMBR attribute value.
Usage
Use this command to map the Maximum Bit Rate AVP received in Update PDP Context QoS message from
SGSN to Aggregate Maximum Bit Rate attribute value (AMBR), if AMBR is not received in Update PDP
Context QoS message from SGSN.messages received from the SGSN.
SGSN to Aggregate Maximum Bit Rate attribute value (AMBR), if AMBR is not received in Update PDP
Context QoS message from SGSN.messages received from the SGSN.
Important:
To use this command event trigger for QoS-Change for session must be provisioned on PCRF.
Example
The following command configures the GGSN service to map the MBR received in Update PDP Context
QoS message from SGSN to Aggregate Maximum Bit Rate attribute value (AMBR):
QoS message from SGSN to Aggregate Maximum Bit Rate attribute value (AMBR):
gtpc map-mbr-ambr