Cisco Cisco ASR 5700
Call Control Profile Configuration Mode
local-cause-code-mapping congestion ▀
Command Line Interface Reference, StarOS Release 17 ▄
1983
esm-cause-code { congestion | insufficient-resources | service-option-
temporarily-out-of-order }
temporarily-out-of-order }
Specifies the EPS Session Management (ESM) cause code to return when a UE requests access when the
system is exceeding any of its congestion control thresholds.
system is exceeding any of its congestion control thresholds.
congestion
- Default
insufficient-resources
service-option-temporarily-out-of-order
Usage
Use this command to configure the cause code returned to a UE when a UE procedure fails due to a
congestion condition on the MME.
congestion condition on the MME.
Related Commands:
To set the cause codes for situations where a call control profile cannot be attached to a call (for example
new-call restrictions, congestion during new call attempt, etc.), use the
new-call restrictions, congestion during new call attempt, etc.), use the
local-cause-code-mapping
command in the mme-service configuration mode. This command is described in the MME Service
Configuration Mode Commands chapter.
Configuration Mode Commands chapter.
Example
The following command maps the “network failure” cause code to the congestion event:
local-cause-code-mapping congestion emm-cause-code network-failure