Cisco Cisco Packet Data Gateway (PDG)
HNB-GW Service Configuration Mode Commands
hnb-access-mode hybrid ▀
Command Line Interface Reference, StarOS Release 16 ▄
6265
Value “0” disables the mode and refuses the any non-access-controlled UEs to register with a Hybrid HNB
under Hybrid Access mode support.
A maximum of 32 simultaneously registered non-access-controlled UEs from a Hybrid HNB is supported in
this access-mode on HNB-GW.
under Hybrid Access mode support.
A maximum of 32 simultaneously registered non-access-controlled UEs from a Hybrid HNB is supported in
this access-mode on HNB-GW.
Usage
Use this command to configure the HNB-GW service instance for Hybrid Access Mode support and related
parameters.
This command enable Hybrid Access mode support to allow the non-access-controlled UEs that can register
from a Hybrid HNB. If a UE tries to register from a Hybrid HNB with an HNB-GW service instance, which
is already reached to the limit configured through
parameters.
This command enable Hybrid Access mode support to allow the non-access-controlled UEs that can register
from a Hybrid HNB. If a UE tries to register from a Hybrid HNB with an HNB-GW service instance, which
is already reached to the limit configured through
max-non-access-controlled-ue
reg_ue_hyb
the
HNB-GW sends HNB-Registration-Reject message with “ue not allowed in this hnb” cause.
Important:
If Operator has reduced the maximum number of non-access-controlled UEs allowed per Hybrid
HNB during the session, this will not have any effect on already registered UEs/CS-Calls/PS-Calls even if previously
configured
configured
reg_ue_hyb
is beyond the newly configured
reg_ue_hyb
value. Limits is respected while handling new
requests.
Example
The following command configures the HNB-GW service instance to allow 16 UEs to register through a
Hybrid HNB:
Hybrid HNB:
default hnb-access-mode hybrid