Cisco Cisco Packet Data Gateway (PDG)
PCC-Sp-Endpoint Configuration Mode Commands
▀ profile-data
▄ Command Line Interface Reference, StarOS Release 16
7618
Usage
Use this command to allow the operator to specify data-reference and service indication AVP values used in
UDR/SNR message for profile data sent over Sp endpoint when access type is set to Diameter in PCC-Sp-
Endpoint configuration instance.
Default service-indication value varies as per other interface configuration
UDR/SNR message for profile data sent over Sp endpoint when access type is set to Diameter in PCC-Sp-
Endpoint configuration instance.
Default service-indication value varies as per other interface configuration
default profile-data key
is
used to set the service indication value.
Example
Following command set the data-reference value used in UDR/SNR message for profile data sent over Sp
endpoint to default value of ‘
endpoint to default value of ‘
0
’ (zero) and service-indication value as per application logic when access type
is set to Diameter in PCC-Sp-Endpoint instance.
default profile-data key