Cisco Cisco Packet Data Gateway (PDG)

下载
页码 8770
Subscriber Configuration Mode Commands   
▀  default 
 
 
▄  Command Line Interface Reference, StarOS Release 16 
8508 
   
ip
 { | 
allowed-dscp
 | 
dhcp-relay
 | 
header-compression
 | 
hide-service-address
 | 
multicast discard
 | 
qos-dscp
 | 
source-validation
 | 
user-datagram-tos
 
copy
 } 
allowed-dscp
: resets the allowed DSCP parameters to the system defaults: class none, max-class be. 
hide-service-address
: specifies the default setting for hide the ip-address of the service from the 
subscriber. Default is Disabled 
dhcp-relay
: Configured with the DHCP server address during MS authentication. The AAA server sends 
the address of the DHCP server in the Access-Accept message. The DHCP relay uses this address to relay the 
DHCP messages from the MS to the DHCP server. 
multicast discard
: Configures the default multicast settings which is to discard PDUs 
qos-dscp
: Sets the quality of service setting to the system default. 
source-validation
: Specifies the default IP source validation. Default is Enabled. 
user-datagram-tos
 
copy
: Disables copying of the IP TOS octet value to all tunnel encapsulation IP 
headers. 
loadbalance-tunnel-peers
 
Sets the tunnel load balancing algorithm to the system default. 
long-duration-action
 
Sets the action that is taken when the long duration timer expires to the default: detection. 
mobile-ip
 { 
home-agent
 | 
mn-aaa-removal-indication
 | 
mn-ha-hash-algorithm
 | 
reverse-tunnel
 | 
security-level
 | 
send
 { 
dns-address
 | 
terminal-verification
 } 
} 
allow-aaa-address-assignment
: Disables the FA from accepting a home address assigned by an AAA 
server. 
home-agent
: Sets home agent IP address to its default of 0.0.0.0. 
match-aaa-assigned-address
: Disables the FA validating the home address in the RRQ against the one 
assigned by AAA server. 
mn-aaa-removal-indication
: Sets this parameter to its default of disabled. 
mn-ha-hash-algorithm
: Sets the encryption algorithm to the default of hmac-md5. 
reverse-tunnel
: Sets this parameter to its default of enabled. 
security-level
: Sets this parameter to its default of none. 
send dns-address
: Disables the HA from sending the DNS address NVSE in the RRP. 
send terminal-verification
: Disables the FA from sending the terminal verification NVSE in the 
RRQ. 
permission
 
Restores the subscriber’s service usage defaults. 
ppp
 { 
always-on-vse-packet | data-compression
 { 
mode
 | 
protocols
 } | 
ip-header-
compression negotiation
 | 
keepalive
 | 
min-compression-size
 | 
mtu
 } 
Sets the point-to-point protocol option defaults. 
always-on-vse-packet
: Re-enables the PDSN to send special 3GPP2 VSE PPP packets to the Mobile 
Node with a max inactivity timer value for always on sessions. This configuration is applicable only for 
PDSNsessions. 
data-compression
 { 
mode
 | 
protocols
 }: restores the default value for either the data compression 
mode
 
or compression 
protocols
 as follows: 
 
mode stateless