Cisco Cisco Packet Data Gateway (PDG) 产品宣传页
Card Configuration Mode Commands
framing ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
2013
sonet [ ds1 | e1 ]
Configures the system to use SONET signal framing for either an OLC/OLC2 or CLC/CLC2 line card in an
SGSN.
Default: SONET is the default framing type for an OLC/OLC2 or CLC/CLC2 line card.
SGSN.
Default: SONET is the default framing type for an OLC/OLC2 or CLC/CLC2 line card.
Important:
Using this keyword with an Ethernet line card takes the line card offline.
In releases 8.1 and higher, you can also set the type of signaling path for a CLC2.
ds1
- configures the card to support a DS1/T. This is the default for SONET.
e1
- configures the card to support an E1.
unspecified
Configures the system to use the default framing type for the particular line card resident in the identified
slot.
slot.
-noconfirm
Instructs the system to execute the command without additional prompting for command confirmation.
Usage
Use the
framing
command to identify the type of signal framing to be used by the line card in the identified
slot.
Note that each type of line card uses a different type of signal framing. If you configure the wrong framing
type for a line card, the line card is taken offline.
Note that each type of line card uses a different type of signal framing. If you configure the wrong framing
type for a line card, the line card is taken offline.
Important:
This command is not supported on all platforms.
Example
Use the following command to configure SDH signal framing on a CLC2. If you do not include the path-type,
the default of
the default of
e1
is automatically included in the card’s framing configuration:
framing sdh