Cisco Cisco WAP351 Wireless-N Dual Radio Access Point with 5-Port Switch 安装指南

• Mechanical Loading—The Cisco WAP351 should be level, stable, and 

secure to prevent it from sliding or shifting out of position. 

The Cisco WAP351 can be wall- or ceiling-mounted. A mounting kit is 
packaged with your Cisco WAP351. The kit is designed to install your 
Cisco WAP351 to the wall or the ceiling. 

The mounting bracket has some flexibility so that you can reuse existing 
holes drilled for the Cisco WAP351. 

The dimensions for the mount kit screws are as follows:

Insecure mounting may damage the device or cause injury. 
Cisco is not responsible for damages incurred by insecure wall 
or ceiling mounting.

To mount the Cisco WAP351 to a wall or ceiling:

Determine where you want to mount the Cisco WAP351. Verify that 
the surface is smooth, flat, dry, and sturdy. 

Drill two pilot holes into the surface 2.75 inches (70 mm) apart. 

Insert a screw into each hole, leaving a gap between the surface 
and the base of the screw head.

Place the upper slots of the bracket over the screws, adjust the 
screws accordingly, and slide the bracket down until the screws fit 
snugly into the slots.

Using the bracket as a template, drill two more holes for the lower 
screws.

Insert a screw into each lower hole.

1 0.33 in

(7.7 mm)

2 0.86 in

(21.8 mm)

3 0.26 in

(6.5 mm)

4 0.69 in

(17.4 mm)

196243