Cisco Cisco WAP200 Wireless-G Access Point - PoE Rangebooster 發佈版本通知

6

Release Notes for the Cisco WAP200 Wireless-G Access Point with PoE and RangeBooster Version 2.0.4.0 

•

When the Wireless Web Access parameter is set to disabled, WLAN 
clients that are not hosted on the AP Management VLAN are still able to 
access the Web User interface.

•

The Device Name parameters on the SNMP window and the Basic Setup 
window are not synchronized. The parameter on the Basic Setup cannot be 
modified by using SNMP. 

•

While enabling SNMPv3, a user is required to enter the Get Community, Set 
Community, and SNMP Trap-Community strings. These fields should be 
grayed out.

•

The TCP checksum error that resulted in HTTP session failure when the 
device was in Repeater or Bridge mode has been corrected. 

•

WPA-Personal encryption mode error that occurred when the device was in 
Repeater or Bridge mode has been corrected.

•

The device MAC address cannot be overwritten with a default value when 
SNMP is enabled. 

•

Unscheduled Automatic Power Save Delivery (U-APSD) errors have been 
corrected. 

•

When Repeater mode is configured, wireless isolation is automatically 
disabled on first SSID.

•

WEP encryption now includes ASCII mode support. 

•

A WDS Bridge can cause TCP checksum errors on some packets and that 
might result in HTTP session failures.

•

When the Wireless Web Access parameter is set to disabled, WLAN 
clients that are not hosted on the AP Management VLAN are still able to 
access the Web User interface.