Cisco Cisco WAP321 Wireless-N Access Point with Single Point Setup 安装指南
Cisco WAP121 and WAP321 Wireless-N Access Points
5
To mount the WAP device to a wall or ceiling:
S
TEP
1
Determine where you want to mount the device. Verify that the
surface is smooth, flat, dry, and sturdy.
surface is smooth, flat, dry, and sturdy.
S
TEP
2
Drill two pilot holes into the surface 1.85 inches (47 mm) apart for
the Cisco WAP121. For the WAP321, drill the holes 2.75 inches
(70 mm) apart.
the Cisco WAP121. For the WAP321, drill the holes 2.75 inches
(70 mm) apart.
S
TEP
3
Insert a screw into each hole, leaving a gap between the surface
and the base of the screw head.
and the base of the screw head.
S
TEP
4
Place the upper slots of the bracket over the screws, adjust the
screws accordingly, and slide the bracket down until the screws fit
snugly into the slots.
screws accordingly, and slide the bracket down until the screws fit
snugly into the slots.
S
TEP
5
Using the bracket as a template, drill two more holes for the lower
screws.
screws.
S
TEP
6
Insert a screw into each lower hole.
S
TEP
7
Slide the WAP device into the bracket, placing the cables or cords
through the break-out tab found in the back of the bracket.
through the break-out tab found in the back of the bracket.
Connecting the Cisco WAP121 and
WAP321 Wireless-N Access Points
WAP321 Wireless-N Access Points
The default configuration of the device has the Wi-Fi radio turned off. You
must perform the initial configuration using a wired Ethernet connection. To
connect the device to the wired network:
must perform the initial configuration using a wired Ethernet connection. To
connect the device to the wired network:
S
TEP
1
Connect the Ethernet cable to the Ethernet port of a switch or a
router.
router.
S
TEP
2
Connect the other end of the network Ethernet cable to the
Ethernet port of the wireless access point.
Ethernet port of the wireless access point.
S
TEP
3
If PoE is not provided, for the Cisco WAP121 plug in the power
adaptor to provide power to the device. For the Cisco WAP321, the
power adaptor is sold separately.
adaptor to provide power to the device. For the Cisco WAP321, the
power adaptor is sold separately.
After installation, all lights should be active. Refer to
for details about the different lights on each
switch.
4