Cisco Cisco WAP121 Wireless-N Access Point with Single Point Setup 發佈版本通知
12
Release Notes
Cisco WAP121 and WAP321 Wireless Access Points,
Firmware Version 1.0.3.4
Firmware Version 1.0.3.4
Version 1.0.3.4
March, 2013
These release notes describe the changes in the new firmware for the Cisco
WAP121 and WAP321 Wireless Access Points.
WAP121 and WAP321 Wireless Access Points.
New in This Release
Wireless security enhancement. After resetting the access point to factory
defaults, it will use WPA2-PSK security with a device-generated random key.
defaults, it will use WPA2-PSK security with a device-generated random key.
Requirements
•
Your computer must meet the recommended hardware and software
requirements.
requirements.
•
A computer with Browser support for:
-
Internet Explorer v7.0 or later
-
Chrome v5.0 or later
-
Firefox v3.0 or later
-
Safari v3.0 or later
Limitations
CSCty78355—The Cisco WAP321 and WAP121 devices do not support multicast
traffic over Work Group Bridge mode. This is a design limitation of the Wireless
Ethernet in Work Group Bridge. Work Group Bridge translates and maps an IP
address to a MAC address in the WET table, which works only for Unicast IP
addresses.
traffic over Work Group Bridge mode. This is a design limitation of the Wireless
Ethernet in Work Group Bridge. Work Group Bridge translates and maps an IP
address to a MAC address in the WET table, which works only for Unicast IP
addresses.