Cisco Cisco WAP561 Wireless-N Dual Radio Selectable Band Access Point 安装指南
8
Cisco WAP551 and WAP561 Wireless-N Access Points
S
TEP
7
Follow the Setup Wizard instructions to finish the WAP device
installation. We strongly recommend you use the Setup Wizard for
the first installation.
installation. We strongly recommend you use the Setup Wizard for
the first installation.
The Setup Wizard turns on the Wi-Fi radio,
allowing you to connect wirelessly. For more advanced
configurations, see the Administration Guide. A link to the
Administration Guide is found in
configurations, see the Administration Guide. A link to the
Administration Guide is found in
Congratulations, you can now start using your wireless access point.
Suggested Next Steps
In case of an error while installing, try the following troubleshooting
procedures:
procedures:
Troubleshooting
If you cannot display the configuration utility, you can test the ability of the
computer to communicate with the device by using ping. To use ping on a
computer running Windows:
computer to communicate with the device by using ping. To use ping on a
computer running Windows:
S
TEP
1
Verify that the Cisco WAP551 and WAP561 is powered on and the
lights indicate the appropriate links.
lights indicate the appropriate links.
S
TEP
2
Locate the device’s IP address. While there are different ways to
locate your device’s IP address, this procedure uses Cisco FindIT.
locate your device’s IP address, this procedure uses Cisco FindIT.
a.
If you have previously downloaded Cisco FindIT, open Internet
Explorer and launch Cisco FindIT. For more information on
downloading Cisco FindIT, see
Explorer and launch Cisco FindIT. For more information on
downloading Cisco FindIT, see
www.cisco.com/go/findit
.
b. In the Cisco FindIT display, place your mouse over the device’s
name. The device IP address is displayed along with other
device information.
device information.
S
TEP
3
Open a command window by using Start > Run and enter cmd.
S
TEP
4
At the Command window prompt enter ping and the
device IP
address. In this example, we pinged 192.0.2.10.
If successful, you should get a reply similar to the following:
Pinging 192.0.2.10 with 32 bytes of data:
Reply from 192.0.2.10: bytes=32 time<1ms TTL=128
Reply from 192.0.2.10: bytes=32 time<1ms TTL=128
7