Cisco Cisco WAP551 Wireless-N Single Radio Selectable Band Access Point 安装指南
Cisco WAP551 and WAP561 Wireless-N Access Points
3
Cisco WAP551 and WAP561 Wireless-N
Access Points Features
Access Points Features
Front Panel
The front panel of the devices consists of three lights: Power, WLAN, and
LAN. For full descriptions of the colors of the lights and their indications,
see
LAN. For full descriptions of the colors of the lights and their indications,
see
.
A Kensington lock slot is found under the lights.
Back Panel
The back panel of the devices has an RJ-45 Ethernet port. Use the
Ethernet port to power your device using PoE. It is an auto-sensing,
Gigabit Ethernet (802.3) port used to connect your WAP devices to
network devices, such as computers, routers, or switches. Cisco strongly
recommends using Category 5e or better cable for Gigabit
connectivity.
Ethernet port to power your device using PoE. It is an auto-sensing,
Gigabit Ethernet (802.3) port used to connect your WAP devices to
network devices, such as computers, routers, or switches. Cisco strongly
recommends using Category 5e or better cable for Gigabit
connectivity.
Side Panel
The side panel of the devices has a Reset button. See
for
information on the Reset button.
Default Settings
If you are using a Cisco RV Series router, the default range for the DHCP
assigned address is from 192.168.1.100 to 192.168.1.254. Any device
connecting to the same LAN will be assigned an IP address in this range.
assigned address is from 192.168.1.100 to 192.168.1.254. Any device
connecting to the same LAN will be assigned an IP address in this range.
Parameter
Default Value
Username
cisco
Password
cisco
LAN IP Address
DHCP address assigned
by server
by server
Fallback LAN IP
192.168.1.245
Subnetwork Mask
255.255.255.0
2