Cisco Cisco Aironet 1200 Access Point 發佈版本通知
19
Release Notes for Cisco Aironet Access Points for Cisco IOS Release 12.3(7)JA3
OL-10095-01
Caveats
Resolved Caveats in Cisco IOS Release 12.3(7)JA2
The following caveats are resolved in Cisco IOS Release 12.3(7)JA2
•
CSCej31994—Memory dump printed to console is now saved in crash-info log file.
•
CSCej32833—Process watchdog no longer causes crash caused by infinite loop.
•
CSCsb48036—Input queue drops on Radio0 interface with 7920 client are now within limits.
•
CSCsb60564—Access points running 12.3.4.JA no longer crashes with memory corruption &
creates an rcore.
creates an rcore.
•
CSCsb84111—Memory leak in 1200 series access point no longer occurs in
dot11_mgmt_rsnie_accept.
dot11_mgmt_rsnie_accept.
•
CSCsb90645—1200 series access point no longer locks up with 7920 phone.
•
CSCsc01606—Access point association table now complete.
•
CSCsc01614—Memory corruption no longer occurs in 1200 series access points running Cisco IOS
Release 12.3(7)JA.
Release 12.3(7)JA.
•
CSCsc01706—WDS master/backup no longer hangs with Cisco IOS Release 12.3(7)JA.
•
CSCsc04430—Dot11 active wireless clients now show associated wireless IP phones.
Resolved Caveats in Cisco IOS Release 12.3(7)JA1
•
CSCej08390—Reboot loop with snmp-server ifindex persist configured no longer occurs.
•
CSCsb85705—RX byte counter per rate now increments correctly.
•
CSCeg83274—Access point now sends RADIUS state information.
•
CSCsb49385—A roaming workgroup bridge no longer selects a non-optimal root access point.
•
CSCsb56012—Clients are now able to associate when WDS device is down.
•
CSCef77951—Excessive processor memory is no longer held by IRB/CRB rxtypes.
•
CSCsb84048—QBSS functions the same for Cisco Airespace and LWAPP-enabled Cisco Aironet
access points.
access points.
•
CSCee36192—The no snmp-server enable traps tty command is effective through reload.
Resolved Caveats in Cisco IOS Release 12.3(7)JA
These caveats are resolved in Cisco IOS Release 12.3(7)JA:
•
CSCeh43628—1230 series access point no longer exhibits DHCP failure when client is configured
for mixed mode (CKIP and 128-key WEP).
for mixed mode (CKIP and 128-key WEP).
•
CSCeh49024—Memory leak no longer occurs when an invalid layer 3 WLCCP packet is received.
•
CSCsa42443—Autoinstall program now uses hostname from DHCP (if present) when access point
is booted with factory defaults.
is booted with factory defaults.
•
CSCsa66924—Access point no longer crashes and reboots when policy-map command is issued.
•
CSCsa71255—Logging snmp-trap no longer returns to default after reboot.
•
CSCeh26214—IP RADIUS source interface no longer disappears after reboot.