Cisco Cisco MGX 8250 8800 Series FRSM-T1 E1 Service Module 参考指南
Cisco Prime Network Analysis Module Command Reference Guide
Page 29
cdp interval
To set the Cisco Discovery Protocol (CDP) messages interval on the NME-NAM, use the cdp
interval command. To return the CDP messages interval on the NME-NAM to the default value, use
the no form of this command.
interval command. To return the CDP messages interval on the NME-NAM to the default value, use
the no form of this command.
cdp interval time
no cdp interval
Note
This command is not valid for NAM-1 or NAM-2 devices or the Cisco NAM
2200 Series appliances.
2200 Series appliances.
Syntax Description
time
Specifies the CDP messages interval. Range is from 5 to
254 seconds.
254 seconds.
Syntax Description
Defaults
60 seconds
Command Modes
Command mode
Examples
This example shows how to set the CDP messages interval:
root@localhost.cisco.com#
cdp interval 200
root@localhost.cisco.com#
Related Commands
Error! Reference source not found.