Cisco Cisco MGX 8250 8800 Series FRSM-T1 E1 Service Module 参考指南
Cisco Prime Network Analysis Module Command Reference Guide
Page 49
data-source waas
To create Wide Area Application Services (WAAS) data-source, use the data-source waas
command.
data-source waas
Defaults
This command has no default settings.
Command Modes
Command mode
Usage Guidelines
When you enter the data-source waas submode, the following commands are available:
device-id—WAAS device ID. This is a mandatory value.
segment—This is the network segment that needs to be added to the data-source. This is a
mandatory value.
cancel—Discards changes and exits from the subcommand mode.
section.
command section.
name string—Sets the waas data-source name. This is a mandatory value.
show—Shows the current configuration which is applied on exit.
Examples
This example shows how to create a WAAS data-source:
root@nam235Cat6k.cisco.com#
data-source waas
Entering into subcommand mode for this command.
Type 'exit' to apply changes and come out of this mode.
Type 'cancel' to discard changes and come out of this mode.
root@nam235Cat6k.cisco.com(sub-data-source-waas)# ?
? - display help
cancel - discard changes and exit from subcommand mode
device-id - WAAS device ID (*)
exit - create data-source and exit from sub-command mode
help - display help
name - data-source name (*)
segment - network segment to be added to data-source (*)
show - show current config that will be applied on exit