Cisco Cisco Prime Network Services Controller Adaptor for DFA 产品宣传页
© 2015 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information.
Page 28 of 45
◦
OSPF dynamic routing adjacency from the leaf side is established using OSPF area 0 and process ID 4:
that is, OSPF processes are different for the inside and outside interfaces to help ensure process-level
separation.
◦
Both active and standby firewalls need to configure a default route with the next-hop IP address
simultaneously set to both 192.168.14.41 and 192.168.14.42 (FW-OUTSIDE segment):
◦
ciscoasa(config)# route outside 0 0 192.168.14.41
◦
ciscoasa(config)# route outside 0 0 192.168.14.42
For more information, visit
http://www.cisco.com/c/en/us/td/docs/security/asa/asa93/configuration/general/asa-general-cli/route-
vPC+ Configuration Details
As discussed earlier, firewalls need to connect to leaf nodes using vPC+. This section shows the required POAP
configuration in Cisco Prime DCNM. The example in Figure 15 shows the POAP settings for only one of the vPC+
peer switches.
Figure 15. Enabling the vPC+ Feature and All Other Configurations
The vPC+ hosts should be provisioned using the menu shown in Figure 16.