Cisco PowerKEY CableCARD Module 802 安装指南
Rack Mounting
4034718 Rev B
7
Removing the PKES from the Rack
Follow these steps to remove the PKES from the rack.
CAUTION:
Avoid personal injury and damage to this product! Be sure to support the
server from underneath while removing it from the rack. Failure to do so
could result in the server falling to the floor. The server could be damaged
and you could be injured as a result.
Avoid personal injury and damage to this product! Be sure to support the
server from underneath while removing it from the rack. Failure to do so
could result in the server falling to the floor. The server could be damaged
and you could be injured as a result.
Note: You do not need to remove the optional front bezel to install or remove the
system from the rack.
1 Turn off the system and attached peripherals.
2 Disconnect the system from the electrical power.
3 Disengage both thumbscrews from the front panel of the chassis.
system from the rack.
1 Turn off the system and attached peripherals.
2 Disconnect the system from the electrical power.
3 Disengage both thumbscrews from the front panel of the chassis.
CAUTION:
This server is not supported by rack slides. Be sure to support the server from
underneath while removing it from the rack.
This server is not supported by rack slides. Be sure to support the server from
underneath while removing it from the rack.
4 Carefully pull the system forward and out of the rack.