Cisco Headend System Release 2.5
3-2
Enabling CVT Downloads on the DNCS
738185 Rev B
Add an MPEG Source to the DNCS
Introduction
The first step in configuring a CVT download method in your overlapping or
non-overlapping frequency network is to add an MPEG source to your DNCS. This
section provides information on adding an MPEG source to the DNCS.
Adding an MPEG Source
If you have not already added one, your next step is to add an MPEG source to its
corresponding QAM on the DNCS. See the Add an MPEG Source section in Chapter
2 of this guide for the instructions.
After you add the MPEG source to its corresponding QAM on the DNCS, your next
After you add the MPEG source to its corresponding QAM on the DNCS, your next
step is to verify that all DNCS processes are running. Go to Confirm That All DNCS
Processes Are Running, next in this chapter.