Cisco Headend System Release 2.5 用户指南
Chapter 2 Add New BFS Sources
16
4011048 Rev B
8 Click PAT Configuration. The Inband Data PAT window opens.
9 Click New Entry. The BIG PAT Setup window opens.
10 Type 12 zeros (00:00:00:00:00:00) in the Session MAC Address field and press
10 Type 12 zeros (00:00:00:00:00:00) in the Session MAC Address field and press
TAB.
Note: You do not have to type the colons in this field.
Note: You do not have to type the colons in this field.
11 In the Session Number field, enter an even-numbered value that is greater than
200 and record it here _____.
Notes:
Notes:
For recommendations on selecting a session number, go to Select a Source ID
for the New BFS Source (on page 9).
for the New BFS Source (on page 9).
Sessions 1 through 200 are reserved for system-built sessions.
For consistency purposes, Cisco recommends that you use this same session
number while building the BFS Source.
number while building the BFS Source.
The values in the Program Number field and the PMT PID field appear
automatically.
automatically.
12 Click Save.
13 Do you need to add additional inband data carousels to the list?
13 Do you need to add additional inband data carousels to the list?
If yes, repeat steps 9 through 12.
If no, click Close to close the PAT list.
14 Choose one of the following options:
Systems with a BIG: From the Set Up BIG window, click Save and then click
Cancel.
Cancel.
Systems with ASI: From the Set Up BIG window, click Save.