Cisco Headend System Release 2.5 安装指南
78-4003191-01 Rev B
The siteCmd Program
A-3
Set Up the Remote Site
Introduction
Before using the Secure Shell to communicate with a remote site, you need to set up
that site with the DNCS. The instructions in this section describe how to use the
siteCmd program to set up a remote site.
Setting Up the Remote Site
Repeat this procedure for each RNCS site that your DNCS will manage.
1. If necessary, open an xterm window on the DNCS.
2. Follow these instructions to log onto the xterm window as root user.
a) Type su - and then press Enter.
Result: The password prompt appears.
b) Type the root password and then press Enter.
3. Type siteCmd -S and then press Enter.
Result: The following message appears:
Enter the host name of the site you are adding.
Enter the host name of the site you are adding.
4. Type the host name of the remote site you are registering and then press
Enter.
Example: site1
Result: The following message appears:
Enter the IP address of the site you are adding.
Example: site1
Result: The following message appears:
Enter the IP address of the site you are adding.
5. Type the IP address of the remote site you are registering and then press
Enter.
Example: 192.168.100.4
Result: The following message appears:
The following line will be added to /etc/hosts:
Example: 192.168.100.4
Result: The following message appears:
The following line will be added to /etc/hosts:
[IP address] [host name]
Do you want to continue? [y,n,?,q]