Cisco Headend System Release 2.5 安装指南
78-4003191-01 Rev B
RNCS Rollback Procedure
B-3
Roll Back the RNCS Software,
Continued
2.
Type luactivate 1.0.0.x and then press Enter.
Note: Substitute the current version of the SAIlionn package for 1.0.0.x.
Result: The system activates the version of RNCS software that was
Note: Substitute the current version of the SAIlionn package for 1.0.0.x.
Result: The system activates the version of RNCS software that was
installed on your system prior to the upgrade and displays the following
message:
*************************************************************************
The target boot environment has been activated. It will be used when
you reboot.
NOTE: You must use either init or shutdown when you reboot. If you
do not use one of these commands, the system will not boot using the
target BE.
*************************************************************************
In case of a failure while booting to the target BE, the following process
needs to be followed to fallback to the currently working boot
environment:
1. Enter the PROM monitor (ok prompt).
2. Change the boot device back to the original boot environment by
typing:
setenv boot-device disk:a
3. Boot to the original boot environment by typing: boot
*************************************************************************
Activation of boot environment <1.0.0.x> successful.