Cisco Headend System Release 2.5 安装指南
78-4003191-01 Rev B
Initial Installation of RNCS Software
1-7
Configure the ALOM Port,
Continued
13. Did the Login prompt appear after you completed step 12?
•
If yes, follow these instructions.
a) Type admin and then press Enter.
b) Type the admin password and then press Enter.
a) Type admin and then press Enter.
b) Type the admin password and then press Enter.
Result: The sc> prompt appears.
•
If no (the sc> prompt appeared), go to step 14.
14. Type shownetwork and then press Enter.
Result: The system displays the configuration settings you just
established.
15. Review the settings you established in steps 1 through 14 and choose one
of the following options:
•
•
If the settings are correct, go to step 16.
•
If a setting is incorrect, re-run the appropriate command and then go to
step 16.
16. Type console -f and then press Enter.
Result: A message appears that instructs you how to return to the ALOM
port, if needed.
17. Press Enter again.
Results:
•
•
Control transfers to the console of the Sun Fire V240 server (rather than
the ALOM port).
•
The ok prompt appears.
Choices Regarding Installation
The Sun Fire V240 server is now ready for the installation of RNCS software. You
have the following two options:
•
•
Telnet from the DNCS to the just-configured ALOM port by following the
instructions in the next procedure, Connect to the Console of the V240 Server.
Note: Cisco recommends that you select this option in order to test the just-
Note: Cisco recommends that you select this option in order to test the just-
configured ALOM port.
•
Use the laptop to install the RNCS software by following the instructions in Install
the RNCS Software, later in this chapter.